Aftermarket replacement combustion (exhaust) blower with housing. Includes gasket. Fits the following models:

Whitfield Pellet Stoves:

• Advantage I - (WP2)
• Advantage II - (WP2)
• Advantage II-T - (WP2)
• Advantage II-T Classic - (WP2)
• Advantage III - (WP2)
• Advantage Plus - (WP7)
• Explorer - (WF1)
• Frontiersman - (WF2)
• Legend - (WP1)

Replaces Lennox part #s 12056010 and 12026010.

Non-OEM Part # 10-1123
1 Year Warranty.
OEM Whitfield part available HERE.

This blower has a molex plug on the end. If your stove has the older style with two spade plugs, you will want to get the adaptor to maintain the warranty. That adaptor can be found here. 

Installation Instructions: 

Before you start working on your stove always be sure to unplug it.  The combustion blower is located on the left hand side of the stove and can be accessed via the side, or rear panel.  

1. Remove access panel and locate motor
2. Unplug blower from wiring harness
3. Locate the 5 screws that attach the blower housing to the body of the stove
4. Remove the 5 screws
5. Remove old blower and old housing
6. Install new blower gasket and blower
7. Reinstall screws
8. Reconnect wiring harness
9. Reinstall access panels
10. Plug stove in and enjoy the warmth!