Breckwell 1 RPM Auger Motor (12-1011)

Replacement aftermarket 1 RPM auger motor for Breckwell pellet stoves. Fits the Following models:

Note: This auger motor fits all Breckwell pellet stove models produced in 2003 and after, as well as some of the old P22 and P23 stoves. This auger motor has a clockwise rotation on the shaft, a mounting hole drilled in the shaft for a cotter pin and wire leads. Not all stoves use the same connection type, if your unit needs different female/male spade clips, these can be removed and changed out. To best determine compatibility, please double check the spacing on your auger shaft. The auger shaft coils will be spaced 1" apart to indicate set up for 4RPMs, whereas 2" spacing indicates set up for 1RPMs.

Breckwell pellet stoves: 

• P22 Maverick - All Units
• P22I Maverick Insert - All Units
• P23 Sonora - Serial # 7166 to Present, and Units BEFORE serial # 6332
• P23I Sonora Insert - Serial # 2243 to Present, and Units BEFORE serial # 1916
• P24 Blazer - Serial # 53664 to Present
• P24I Blazer Insert - Serial # 53795 to Present
• P1000 Big E - All Units
• P2000 Tahoe - Serial # 11780 - Present
• P2000I Tahoe Insert - Serial # 22208 - Present
• P2700 Mojave - Serial # 8445 - Present
• P4000 Classic Cast - All Units
• SP1000 Big E
• SP1002 Big E II

Note: Serial numbers are approximate and should not be the only source of validation for the part. Serial numbers may be off by as much as 10 units either way.
Non-OEM replacement for Breckwell part # C-E-017 and C-E-017M

US Stove pellet stoves:

• 5040 Pellet Heater

Aftermarket replacement for USSC part # 80642
OEM USSC part here
Aftermarket USSC part

May fit other models, please check your owner’s manual for part number compatibility.